SELF-TIMER
The self-timer built into your SR-T 201 and
202 can be used to delay release of the shutter
for about 10 seconds after actuation.
To operate it:
1. Advance film.
2. Cock the self-timer by moving the lever
counterclockwise as far as it will go (about
80°).
3. To start the self-timer, push the small
release button which is hidden under the
free end of the lever when in its rest
position.
If the shutter is not cocked, the self-timer
will stop operating part way through
,ts cycle;
it
can be reset either before or after advancing
film.
You can override the self-timer's release of
the shutter by pushing the
shuttcr-,elcQse but·
ton
to trip the shutter at any umo before the
self-timer has started operating.
You can interrupt the self-limo,
's operation
at
any time and can reset the lever LO ,
ts cocked
position after it
is halfway through
,ts delay.
To Next Page
Loading...
