Minolta SRT 101 - N. Dismounting of Shutter curtains

hoy
N. Dismounting of Shutter curtains
Disrmantle the bottom cover. (See P. 5).
Dismantle the front base frame. (See P. 7). 7
Dismantle the shutter base plate-B. (See P. 15).
Loosen
and
take
out
two
setscrews(B11-1.7%1.9,
B31-1.4%2.5)
from
the
front
side
of
the
camera
body
and
then
take
out
the
front
light
shield
plate(1026).
Expose
the
bottom
of
the
camera
body
and
then
disconnect
the
soldered
portions
of
the
lead
wires(two
yellow
colored
one
sand
red
and
orange
colored,
and
for
the
semi-fixing
resistor)
of
the
battery
switch
isolation
plate(4271)
and
the
lead
wires(black
and
blue
colored,
and
for
the
semi-fixing
resistor)
of
the
isolation
base(4259),
then
loosen
two
contactor
setscrews(9163) and remove the contactor isolation base(4259 set).
Disconnect
the
revertion
spring(2523)
engaged
with
the
pre-set
lever
stopper(2507)
and
then take out the nail ratchet spring A, B(2074, 2075) from the adjusting nail axis(9205).
Unscrew and take out two the curtain spring adjusting mail rathcets(2073) (left handed
screw).
Loosen and take out two setscrews(B13-1.7 3) and take out the lower plate(2076). Then
pull
out
the
spring
shaft
for
the
first
and
second
shutter
curtains
and
then
take
out
the
first and second curtains from the front of camera body.