Minolta SRT 101 - M. Dismounting of Sprocket

1.
2.
3.
M.
Dismounting
of
Sprocket
Dismantle
the
shutter
base
plate
B.
(See
P,
15).
Take
out
two
setscrews(9103)
of
the
middle
contactor
base
(2224)
from
the
camera
body
and
then
the
contactor
base
(2224
set).
Take
out
from
the
bottom
of
the
camera
body
the
charge
lever-A
axis
(9006)
and
let
the
charge
lever-A
(3061)
free
toward
the
outside
of
the
camera
bedy.
Then
disconnect
the
sprocket
lock
lever
spring
(3067)
engaged
with
the
sprocket
lock
lever(3066)
and
take
out
the
lock
lever
axis(9004)
and
the
lock
lever(3066).
Open
the
back
cover
and
hold
the
sprocket
when
the
rewind
release
button
(3053)
(left
handed
screw)is
loosened
and
taken
out
from
the
bottom
of
the
camera
body.
Take
out
also
the
sprocket
spring
(3051).
Take
out
the
coupling
washer
(IE-1.5)
embedded
into
the
shutter
release
shaft
(3028)
from
the
front
of
the
camera
body.
Then
release
the
release
stop
lever
of
the
bottom
of
the
camera
body
so
that
the
shutter
release
shaft
(3028
set)
may
be
pulled
out
upwardly.
Loosen
and
take
out
two
setscrews(B31-1.4%3)
and
then
pull
out
the
sprocket
gear
shaft
bearing
(3048
set)
and
the
sprocket
shaft(3049).
Then
loosen
and
take
out
three
setscrews
(B31-1.4%2.5)
and
take
out
the
sprocket
shaft
bearing(3050)
and
the
sprocket
(3046)
from
the
camera
body.
Fig. 12
Paar 1.4 X39
|
vl
J