Minolta SRT 101 - Page 29

Engage the connecting string for a pointer(50%3) and
loosen two setscrews(Bll-1.4%2.5) for the index
position adjuster (2163) on the shutter mount base plate
-A. Then move the adjuster(2163) in such a manner
that the screw head of the setscrew is located at the
center of the elongated slot of the adjuster (2163) and
then tighten the setscrew. Set the shutter base plate
-A to bulb and one knot portion of the index coupling
string (5053) is inserted throuth the hole of the joint
gear(2154) on the shutter mount base plate A and
pulled out outwardly of the camera body from the
beneath of the film sensitive ring(2010) so that the
knot portion is engaged with the slot of the adjuster
(2163), as illustrated in the figure. Rotate but not
twist the shutter speed cam shaft (2156) unerneath the
sensitive ring(2010) so that the coupling string (5053)
may be engaged into the slot of the string pulley (4017).
Rotate the cam shaft(5056) in the clockwise direction
four times so that the notch portion of the cam shalt
(S056) may be positioned at the right overhead position.
Engage the coupling string (5053) with two position of
the
index
pulley(5073)
in
such
a
manner
that
the
coupling
sting(5053)
may
not
be
twisted
and
connect
the
knot
portion
to
the
notch
portion
of
the
index
spring
outer
tube
(5056)
.
Fig. 30
Four times rotate
the clockwise direction
Next,
set
the
shutter
position
of
the
shutter
base
plate
A
to
250
or
125
and
install
the
coupling
string
(5053)
in
such
a
manner
that
the
coupling
string
(5058)
maybe
set
to
the
numeral
250
or
125
or
the
numeral
indicator
plate
within
the
view-finder
as
illustrated
in
the
figure
and
paste
the
same
in
position.