Minolta SRT 101 - Page 28

When the adjustment is to be made from the
befinning, turn the adjustment screws about three
turns to raise them from their initial positions
where the adjustment screws have been screwed
first. Then, start adjustment from such raised
pesitions, When adjustment is made, care should
be taken not to disconnect the lead wires or give
darmmage to the meter since the yare located adjacent
the adjustment screws. When the following
adjustment
from
a)
to
d)
is
made
and
when
you
look
the
image,
care
must
be
taken
to
lightly
press
or
hold
the
pinchers
portion.
Then,
tighten
three
setscrews(9132)
and
check
again if the image is in focus at such tightened position.
a) When the left portion is of a wave form as illustrated
in the right figure, the left side is insufficient so that
the
focus
adjusting
screw
on
the
left
must
be
lowered
for
adjustment.
/\
b)
When
the
left
portion
is
of
crossing
waves
form,
the
Left
side
left
side
is
over
or
in
excess
so
that
the
left
side
hc
ccciacsos
focus
adjusting
screw
must
be
raised
for
adjustment.
Conversely
when
the
right
side
is
of
a
wave
form
or
crossing
waves
form,
the
right
side
is
insufficient
or
excess
respectively,
so
that
the
right
side
focus
Left
side
over
adjusting
screw
must
be
adjusted
accordingly.
c)
When
the
lower
portion
is
of
a
wave
form
as
shown
in
the
right
figure,
the
lower
side
is
insufficient
so
that
the
lower
focus
adjusting
screw
must
be
eve
lowered
for
adjustment.
insufficiency
I
d)
When
the
lower
portion
is
of
crossing
waves
form,
a
we,
Fig. 26
the
lower
side
partion
is
in
excess
so
that
the
lower
side
focus
adjusting
screw
must
be
raised
for
adjust-
.
ment.
Conversely
when
the
upper
portion
is
of
a
wave
form
or
crossing
waves
form,
the
upper
side
is
insufficient
or
in
excess
respectively
so
that
the
right
and
left
side
focus
adjusting
screws
must
be
adjusted.
@.
Connect
to
the
wire
cord
lug
plate(4275)
below
the
following
pointer
base
plate
the
lead
wire
(black
colored)
from
the
front
side
of
the
camera
body
by
soldering.
Pull
out
from
below
the
pressure
spring
(S069)
and
connect
the
lead
wires
(white
and
orange
colored)
to
the
wire
printed
plate(4265)
by
soldering
as
indicated
in
the
figure.
Take
out
two
setscrews(9158)
and
the
eye-piece
frame(5061
set).
Lower side over