Minolta SRT 101 - Page 38

3. Attachment of AV and TY strings: Fig. 53
Attach the MC standerd F1.4/sa8mm lens to
the body bayonet mount and set the diaphragm
ring to F4. Then attach the TV pulley press
nut
jig(O3Y~0013-79)
to
the
rewinding
shaft.
One knot portion of the TV coupling string
(4081) is to be inserted into the slot of the
film sensitive ring(2158) of the shutter base
plate-A, and then pull out the coupling string
(4081) below the sensitive ring (2158). Gee
Fig. 53). Fix the speed dial ring(2155),
the sensitive plate spring (2005), the sensitive
plate sheet (2153 set) and the speed dial scale
plate(2151)
to
the
shutter
base
plate-A
by
a
|
means
of
one
setscrew(B31-1.7x%2.5).
(Gee
|
|
P. 24) Set the speed dial to 1/30sec. and
ASA 50.
Rotate about two and half turns the following
pulley
holder(4070)
of
the
needle
following
base
plate
(4072
set)in
the
counter
clockwise
Needle
following
t
direction
and
attach
the
needle
following
cam
position
adjusting
jie
{t—
position
adjustment
jig(03Y-0007-79).
Rotate
the aperture value pulley (4069) in the clockwise
direction so that the switch lever(40s8)
attached to the pulley(4069) and made of
Fig. 54 BII-1.7%3.3 a |
bakelite is abutted against the pin of the jig
plate. (See Fig. 54) The lengths of the AV
coupling
string(4080)
and
the
TV
coupling
string (4081) are 195mm and 237mm respec-
tively,
When
they
are
exchanged,
the
permissable
dimension
of
the
knot
portion
must
be
within
the
order
of
+1mm.
Otherwise,
adjustment
after
attaching
the
strings
can
not
be
made.
When
the
strings
are
attached,
care
should
be
taken
not
to
overlay
the
AV
string
(4080)and
the
TV
string(4081)
on
each
other.