Minolta SRT 101 - Page 39

|
oa
|
Fig. 55 —
AV coupling string (4080):
Check if the AV string (4080) extending from the front frame is not disengaged from the
middle pulley-A (1068). Engage the AV string(4080) to the middle pulley band-C (4073,
4074).
In
this
state,
insert
the
AV
string(4080)
into
the
slot
provided
around
the
AV
pulley
(4069)
of
the
needle
following
base
plate
in
the
clockwise
direction.
Insert
the
AV
string
(4080)
into
the
slot
portion
of
the
AV
pulley
(406)
and
then
wind
around
the
pulley
of
the
pulley
holder
(4070
set)
from
the
lower
side
thereof,
Engage
the
knot
portion
with
the
upper
slot
portion
from
the
beneath
of
the
TV
pulley(4068),
which
is
then
turned
lightly
in
the
clockwise
direction
so
that
the
AV
string(4080)
may
be
tightened.
Fig. 56
TV coupling string (4081):
First
set
the
camera
to
EV
9,
that
is
ASA
50,
shutter
speed
1/30
sec.
and
F4
and
then
wind
about
one
and
a
half
turn
in
the
clockwis:
direction
the
TV
string(4081)
extending
from the shutter base plate-A around the film sensitive ring(2158). Wind the TV string
(4081)
around
the
middle
pulley-C
(4074),
two
places,
and
also
around
the
TV
pulley
(4068)
of
the
needle
following
base
plate
in
the
counter
clockwise
direction
about
one
tum.
The
string
must
be
passed
into
the
inside
from
the
notch
portion
of
the
TV
pulley(4068)
as
indicated in the figure and the knot portion must be engaged with the notch portion of
the adjusting ring (4082).