Minolta SRT 101 - Page 40

6 Cam position adjustment :
9.
Loosen two setscrews(B11-1.4%1.6) of the
adjustring ring(4082) and rotate the TV
pulley (4068) in the clockwise direction and
the adjusting ring (4082) in the counterclock-
wise direction so that the AV and TV
(4080, 4081) may be tightened. The knot
portion and the portion inserted in the slot of
the AV string(4080) are pasted to hold it in
position. Paste the only knot portion of the
TV string (4081). Set the camera to EV 10,
that is ASA 50, shutter speed 1/60 sec. and
F4 and loosen two setscrews(B11-1.4% 1.6) to
move the adjusting ring (4082) for adjustment
so that the straight portion of the following
pointer coincides with the EV 10 line of the
following cam position adjustment jfig(o3Y-
007-79).
Insert into the needle following axis (4052) of
the base plate(4072 set) the following return
spring(4057) with its bended portion being
facing upwardly, and the insert the needle
following rotate axis(4054 set). Engage the
return spring (4057) with the rotate axis (4054
set) as indicated in the figure, and insert the
following upper lever(4056). Then, tigthen
the following lever mut(9451) and fit the
coupling washer (E-1.2) into the notch portion
of the following axis (4052).
* Needle following lever opening angle adjust-
ment :
This is the adjustment for calibrating the
errors and deviation of the following cam and
the meter following needle. Set the camera
to EV 10 that is ASA 50, shutter speed 1/60
and F4 and then adjust by rotating the upper
lever eccentric pin(9208) of the rotate axis
(2054 set)so that the following needle within
the meter may coincide with the checker
point in the figure.
Take
out
the
lens
or
connecting
ring
Fa
set
jig
and
the
following
cam
position
adjustment
jig.
Fig. 57
Fig 4586
Needle following cam
ee of EV 10 : °
E-12
ia i- 17X33
425 1set
Bij-1.4%2
At wide open At close down