Minolta X-300 - Page 19

Mi Overrun eccentric pin adjustment
1. After winding, hold the film advance lever and turn the eccentric pin (9291) counterclockwise
until the sprocket shaft (3052) touches the winding shaft receiver. (Fig. 1)
2. Return the winding lever slightly, and then wind it again to set it in the condition shown in
Fig. 2.
Fig.
1
MFig.
2
Winging shalt recerwer
Sorochat snaft a)
3. Then, shift the sprocket shaft by finger toward the body center to set it in the condition
shown in Fig. 3, and slowly turn the eccentric pin (9291) clockwise until the overrun preven-
tion lever is engaged with the ratchet of the sprocket shaft.
BFig. 3
9291
®
Checking
adjustment
:
During
the
winding
lever
operation,
the
end
of
the
overrun
prevention
lever
should
not
be
caught
by
the
sprocket
claw.
After
winding
is
completed,
the
lever
should
he
engaged
with
the
claw.