Minolta X-300 - Page 21

(B)Check and adjustment of winding operation lever timing
* After winding completion, slowly return the film advance lever. The winding stop lever should
engage on the ] st stop position of the charge operation plate. Before it engages or. the 2nd stop
position, () the winding claw and @) the winding operation lever should disengage from the wind-
ing operation plate. The order of () and @ is reversable.
* And also make sure that a clearance should be visible between winding stop lever and charge
operation plate after winding stop lever engages with the 2nd stop position of charge operation
plate.
BFig. 3
Charge ooeration plate
If adjustment is not made well as mentioned above, replace winding stop lever with a new one.
Timing
failure
of
winding:
operation
Fig.
4
Types
of
winding
stop
lever-A
set
lever
may
occur
by
replacing
parts
of
Parts
No.
|
Mark
Limm!
winding
mech.
with
accumulated
Wd
2017-0312-01
|
no
marked|
8.6
tolerance
of
each
part.
(vO)
2017
-0322-9)
marked
|
4.3
Punch mark
BNote:
The following symptons may occur by replacing parts of the winding stop lever A-set even timing
of winding operation lever is normal.
L The symptom of replacing 0322-01 hy 9312-01.
Idle
winding
may
takes place
cause
of
winding
claw
is
not
engaged
even
wiading
stop
lever
engaged on 2nd stop position.
The symptom of replacing 0312-01 by 0322-01.
Winding
stop
lever
may
not
engage
on
the
2nd
stop
position
or no
clearance
appears
even
winding stop lever engaged.