Minolta X-300 - Page 26

15
Mi Shutter gear position adjustment
1. Engage the gears so that the mark of charge gear A faces the center of charge gear C, and
tighten 9012. The gear engagement clearance should be 0.1~0. 2mm.
MFig. 1
Wi Shutter release procedure
Miln this camera, the mirror operation mechanism is started with the separation of the release
magnet (R Mag). Therefore, after mounting the shutter block on the body, the shutter cannot
be released unless the flexible P.C board is installed with the wiring completed. For this
reason, the shutter should be released by the following method when performing any checking
or adjustments, such as for winding, mirror box, shutter release, etc., after assembling the
front base plate block as shown on P. 14.
(By using a release too! (2017-0003-75)
Release the shutter by pressing the release
R mag lead (Green) +
(2)By using a battery
(—) Side
= = Sy re >
: a
a@
° ames
, : @Q=
\\ R mag lead (White)
Ro mag lesd (Green)
‘0
WiCaution : In both methods []) and (), supply power until the completion of shutter operation.
(Otherwise the shutter tester may fail to give a correct indication.)