Minolta X-300 - Page 27

Hi Shutter charge adjustment
1.
Slowly turn the film advan-e lever and check the over-charge from the time the 2nd curtain
is stopped (the 2nd curtain stop lever moves from @ to @, as shown below) until the film
advance lever stops by checking the movement of the sprocket idler gear.
BFig. 1 Overcharge should be 1~1.5 teech
Sorccket idler guar ;
internal Deteeen marts 14 equivalent to 1.5
of one sprocket idler gear tooth
2 ng curtain stoo wer
Caution! [f the winding operation is not smooth, or if the overcharge exceeds two teeth,
immediately stop winding and adjust.
WAdjustment procedure
@ Overcharge is less than | tooth------ Turn the eccentric pin (9281) counterclockwise.
@ Overcharge is over 1.5 teeth -------Turn the eccentric pin (9281) clockwise.
Fig. 2
[B] +2080 14018)
‘atter adusiment)
elf
the
adjustment
by
the
eccentric
pin
is
not
sufficient,
shift
charge
gear
A
by
one
tooth.
‘In
the
case
of
an
undercharge,
shift
it
in
the
direction
of
‘3),
and
in
the
case
of
an
over-
charge, in the direction of ‘b), as shown in Fig. 2.)
16