Minolta X-300 - Page 37

3.
Push
up
the
mirror
sub-stopper-B
until
its
end
lightly
touches
the
mirror
operation
lever
pin, and then tighten the setscrew.
BFig. 8
Let it toven ligntty (ao not keep it pressed
—-@ go of less tan QO) mm ia allowable).
Mirror tu itopper-6
4. Operate the mirror several and make sure that the chart image is within the standard
Fig. 9
1? circie
2 ocrcie
3 circie
@45°+10'++10° cirele must be in touch
: with the cross (vertically
and horizontally).
olf it is not within the standard 45°>10°. perform adjustments 1~3 again.
. After compieting the adjustment, apply screw-lock (3-BOND 14018) to the screw head of
mirror adjusting plates A, B. and the mirror sub-stopper, and adhere the flare prevention
sheet B (5030---P. 37)
i
Sub
materials
WiGrease
@® = 73340
e=335
e =704
i Anti-diffusion agent
e FC-721
(Dilute with solvent FC-77 by 1 : 10)
Boil
Adhesives
Mi
Cleaner
e
2012
@3-BOND
1401B
e
FLONSOLVE
e
PLIOBOND
@ SILICON-BOND KE-441RTV
@ ALTECO CN2
@ LOCKTITE 242
@ SONIBOND SC-108
' @ EVERGRIP