Minolta X-370 - Loading Film into Camera

LOADING FILM
Before opening the camera back,
make sure there
is no film inside
the camera
by checking the Safe
Load Signal (p.
15).
NOTE
• When loading film in a dark place
or with the lens cap on, loading
will be easier if the mode selector is
not set at "AUTO " .
1. Unfold the rewind crank and
pull up on it to lift the back-cover
release
knob . Pull up on the knob
unt il the camera back springs open .
2. Leaving
the knob pulled out ,
position a 35mm film cartridge in
the chamber with its project i ng
spool down. Then push the back-
cover release k
nob all the way in,
rotating it slightly if necessary .
•
Always handle and load film in subdued light - at least shaded
from direct light by your body .
• Do "" ''''h '"V P"" "'"'' ~ ~ O J JI
inside the camera shown in blue . ~
13