Minolta XE - S Button Lock Lever Operation Check; Spacing Adjustment of SW.1; POINT-4 Installation of S.S. Dial Pulley; Print Base Plate-B

16
BS Button Lock Lever WSpacing Adjustment of
=
Operation
Check
Sw.1
%*% In case of ON, contact pressure should exist.
With SW turned in the arrow
direction,
S
button
lock
AT
Bend 4034
for
lever
should
be
released
and
fp
adjustment
aapnen
the
S
button
should
be
able
Se
to be pushed ‘Ce S$ button lock lever Je
a2
f=
[G]
No.335
Clearance of 0.4mm
fin case of OFF)
POINT-4 Installation of S.S. Dial Pulley
MWith
shutter
speed
of
AUTO,
the
brush
holder
(0213)
is
in
the
position
shown
below.
Slot of SS dial pulley
Set so that the slot of SS dial pulley can be
in the center of projection indicated by oblique
lines.
M@Print
Base
Plate-B
MFor mounting each part, refer to the drawing below.
8306
8304
8305