Minolta XE - Body-5 Film Advance Operation Lever, Film Advance Operation Ring and Film Advance Axis Base Plate; After assembling, make the following adjustments:

Body-5
Film
Advance
Operation
Lever,
Film
Advance
Opera-
tion
Ring
and
Film
Advance
Axis
Base
Plate
oe
3074 After the film advance operation lever is
~ installed, incorporate the film advance axis ‘
bearing.
Bes) Film advance axis base plate
0150
3009
[A] See Fig-7
9613-2060-01
_
j
Film
advance
operation
ring
Arn
alpha
ar
sf
we
See
Fig-6
After installing, check vertical shaking of the
= film advance axis. If shaking is excessive,
make adjustment by means of the adjusting
washer. Excessive shaking may cause 3070
at the body bottom to go off.
9791 -4258-50 |, ws)
9792-4258 -20
9034
3075
Film advance operatior
lever
0126
9033
Fig-6 How to engage 3075 SP 3074
Fit this to the body
@
No.335—~\
[4] While supporting the film advance axis upward with
~ your finger, incorporate the above parts.
WAfter assembling, make the following adjustments: (refer to next page *)
@ Adjustment of film advance operation lever disengagement timing.
@ Adjustment of reversing stop nail B engagement timing.
@Checkup of operation timing of film advance nail and film advance stop lever.