Minolta XE - Adjustment of Film Advance Operation Lever Disengagement Timing; Adjustment of Reversing Stop Nail B Engagement Timing; Checking of Operation Timing of Film Advance Nail and Film Advance Stop Lever

WAdjustment of Film Advance Operation Lever
Disengagement Timing
@ Purpose and caution:
This adjustment is to release the film advance lever (3007) at the same time as the
completion of winding.
* Releasing too quickly will cause undercharge.
* Releasing too slowly will cause the film advance lever not to return.
e@Preparation. Temporarily set the film advance lever
®Procedure: Carry out the adjustment according to the following procedures.
WBefore
winding
up
condition
HiCondition at the completion of winding up
@ In the state of completion of film advance, loosen 9037 and
release 0126
@ Push 3007 in the arrow direction as in the figure below
and press it to the oval hole. :
@) Push 0126 in the arrow direction as in the figure below,
. move it until 3007 is removed, and tighten 9037.
(4) Wind up again and check that 0126 is released just before
the winding up is completed. Afterward, tighten the lock
screw at 9037.
a
9037
Screw lock
0126
3007
Wi Adjustment of Reversing Stop Nail B Engagement Timing
@ With the body bottom up, if 3065 is in either of
the situations shown below in relation to 3023,
loosen 9007 and make the clearance 0 by means of
eccentric adjustment.
@
@) Complete winding up.
9007
Ridden over
9419
@) Push 0126 in the arrow
direction
and
release
the
(4)
Confirmation:
0126
should
be
able
to
be
released
after
winding
up
and
3065
being
engaged
with
3023,
or
at
the
same time thereof.
film advance lever as 3007
is contacted.
WiChecking
of
Operation
Timing
of
Film
Advance
Nail
and
Film
Advance
Stop
Lever
ry
Clearance
Clearance of
approx. 0. 8mm
(4) Make sure that the
film advance lever
(2) Check and ensure
fn
that the film advance @ Make sure that the
film advance nail
@) Restore to the origi-
nal state gradually nail is in the posit-
from the wound up
state.
MLower side of body
ion shown above in
which the film adva-
nce stop lever is°
engaged with the
first notch.
falls within the range
where the film adva-
nee stop lever falls
into the second notch.
is in the completely
returned position as
shown above.