Minolta XG-9 - Standard Lens Specifications

The Auto Electroflash 132X features twO
auto setting as well as manual and a tiltable
flash head for bounce flash. Its special flash
distance check
lamp lights to indicate when
flash brightness is sufficient for correct expo-
sure.
The series-SCR circuit in the Auto Electro-
flash 200X ensures fast recycle time (min. 0.5
sec.) and enables the
unit, powered by Ni-Cd
batteries
to make up to two continuous-se-
quence flash exposu
res each second with the
Auto Winder G.
For both units, switching the power "OFF "
cuts
off all flash circuits and normal automatic
or manual operation is returned to the XG -9.
The camera
may then be used in either mode
even with the flash attached.
Remote Cord Sand L
These cords are designed
for operating the
XG -9 from a distance. Each screws into the
shutter release socket on the side of the lens
mount . The Cord S is 50cm (about 20 in.) long,
while the Cord L is 5m (16-1/2 ft.!. These cords
facilitate shots mounted on a tripod or remote
wildlife pictures. In combination with the Auto
Winder G, the Cord L can be used to make
single or continuous sequence exposures at the
subject pOSition, from a remote location, etc.
47