Minolta XG-M - Battery Holder and Installation

JECK STRAP
BATTERY HOLDER
7
For carrying convenience and safety, this
strap can be attached to the camera by means
of the strap eyelets on the camera body.
To attach, follow the steps illustrated.
'r.
A holder for carrying spare batteries is
provided with this camera strap. To install
batteries, follow the steps illustrated. Slide the
holder off the strap to remove batteries.
8
ATTACHING AND REWIOVING LENSES
To Attach
1. Remove the body cap from the camera lens
mount and the rear cap from the lens
bayonet, each by turning the cap counter¬
clockwise.
2. Align the red mounting index on the lens
barrel with the red index above the camera
lens mount; insert the lens bayonet into the
mount; and turn the lens clockwise until it
locks into place with a click.
To Remove
While pushing the lens-release button, turn
the lens counterclockwise as far as It will go;
then lift the lens bayonet out of the mount.
CAUTION
If it becomes necessary to set the lens down
without a rear lens cap attached, be sure to set
the lens only on its front end (except for
fisheye lenses) as damage to the diaphragm
control pin could result from rear lens contact
with a hard surface.