1. Push down to open the battery compartment cover (10) as shown in Fig.1.
2. Insert a 9V battery into the battery compartment according to the correct polarity as
shown in Fig.2 Then push up to close the battery compartment as shown in Fig.3.
3. The LED indicator flashes briefly at power on indicating normal battery status. If no
flash occurs it has either no battery, the battery is drained or is installed incorrectly.
Change accordingly.
4. Phone Jack (if fitted): When the switch is in the 'up' position, the volume control is
bypassed and the level is set to maximum. When switch is at 'down' position the
volume control is fully operational (3). Adjusts the audio input level from the
microphone/auxiliary source, to the transmitter (4).
5. 4-Pin Jack (if fitted): Volume can be adjusted via the Gain control. The Gain control
has no effect when switched to GT (Guitar) usage.
6. 4-Pin Jack: Align and insert the plug to jack accordingly and tighten it in the
clockwise direction as shown in figure 4.
7. Phone Jack: Insert the plug accordingly and tighten it in the clockwise direction.
Operating Instructions
BATT.LOW
OFF ON
+
-
(Fig.1) (Fig.2) (Fig.3)
Lavalier
Headset
Please aim of the fillister
and insert the connector
Capsule Connectort
MIC
(Fig.4)
Belt Pack Transmitter
Operating Manual
- 13 -
To Next Page
