ACT-707TE
ACT-3T
1. Pushing down both snap locks on the sides of battery cover to open battery
cover. Take out the batteries. Fig. 5).
2. Insert two 1.5(AA) batteries into the battery compartment according to the correct
polarity as shown in Fig. 5). Then push up to close the battery compartment as
shown in Fig. 5-1).
1. Pushing down both snap-locks on the sides of battery cover to open battery
cover. (Fig. 4).
2. Insert a 9V battery into the battery compartment observing the correct polarity as
shown in Fig. 4). Then push up to close the battery compartment as shown in
Fig. 4-1).
Operating Manual
BODYPACK TRANSMITTER
4. Battery Installation
()Fig. 4 ()Fig. 4-1
()Fig. 5 ()Fig. 5-1
PS: When the microphone is not in use:
Make sure the power of the microphone is off. If the microphone will not be
used for some time, please remove the batteries from the battery compartment
to avoid battery leakage and result in damaged battery springs and circuit. If a
rechargeable battery was used, take it out and recharge it.
-24 -
To Next Page
