Service and repairs, trouble shooting
• Arrange the prescribed setting-, servicing- and checking works to the limit date.
• The users must be informed about imminent servicing and repairs of the device.
• All of the device pre- or after switched machine parts and operating mediums, e.g. electricity,
must be ensured against accidentally launching.
• By all servicing-, checking- and repairing works, the device must be switched off from main supply
and the mainswitch must be locked against unexpectet restarting
- Lock and strip of the key from the main switch, if it is possible.
- Add Add a shield or Information on to the device, which the device may not be able to be
switched on.
• Greater devices must be carefully mounted and ensured on lifting gears, by the replacing.
• Check loosened screw connections for a compact seat.
• After finishing the service work, the saftey apparates of the device must be checked and verified.
Constructive modifications on the device
• Without written authorisation by the manufacturer Minelli Corp. (MIRA), theres no right to add
some components and/or making some modifications on the device. This is also valid for welding
wearing components.
• All constructive modifications requires a written affirmation from the Minelli Corp. (MIRA)
• Faulty device parts must be replaced by original replacements only.
• Only use original genuine mira replacement parts.
- By replacements of externals, there are no guarantee, that they are constructed for the required
operational demands and the required safety functions.
Cleaning of the device and disposal of wastes
• Used stuff and materials must be correct removed and handled, especially:
- by works on greasing systems- and devices
- by cleaning with dissolvers
• The device must be cleaned external in constant intevalls, with a flannel and less of machine- or
industry cleaner.
• Further cleaning per grade of using and grade of pollution of the device.
• The packaging material of the VGX-21, after delivering, must be correct disposed in the respective
waste container and/or according to local envirement legislations!
Noise emission of the device
• The noise pressure level going out from the VGX-21, behave to 0dB(A)
• In combinated use with the Vario Drive System, there is a noise pressure level up to 70dB(A)
going out from the Vario Drive.
• Based on the local environment, there is a possibility of a higher noise pressure level. This can
cause noise deafness. In this case, the users must be wearing protection devices (e.g. hearing
protection, Oro-pax etc.)
Safety advices for carrying
• For transport, the VGX-21 must be carried in the storage box (in the same as it was delivered
from the Minelli Corporation).
• Ensure all moving parts from the device against loosening, by the transport.
• The device must be protected against damages by the transport. If essential, the device can be
fully packed in.
• The MINELLI Corporation will not take liability for ignoring and not paying attention of the safety
regulations by shipment.
To Next Page
