Miracle-Gro Twelve - Set up Your Plants

8
Choose Your Location, Fill with Water
• Your Miracle-Gro® Twelve™ Indoor Growing System
holds two gallons of water and when it’s full it can be
pretty heavy, so make sure you have it in its preferred
location before adding water to the reservoir.
Remember to keep your unit unplugged until you’ve
illed it with water and inished the setup instructions.
• When you’re ready, ill the reservoir with two gallons
of water (Look for the ill line on the inside wall.).
Return Parts to Top of Reservoir
• Place all loose components back into original places
in the reservoir with the exception of the planting site
covers [M]. Then, install the safety screws [K] at the
outside ends of the middle cover plate [G].
FILL LINE
E
Set Up Your Plants
TIP:
Be sure the nozzle lines up with the cutouts on the bottom of
the middle cover plate [G] so the plate its lush with the frame.
G
NOZZLE
When moving your unit, lift it by the steel legs, not the shade.
Be sure you look for a place with an outlet nearby.
TIP:
L
K
F
G