제 7 장 SET UP 7-7
R-axis Origin Offset R-axis Origin Offset should be set for a machine equipped with a
directional nozzle
Setting socket such as odd shaped machine. Since the nozzle itself is directional, it should
also be inserted into the ANC in a correct direction. For calibration,
install the jig at each R axis in case of precision head and at the first
head of each axis in case of module head.
Recheck Head Offset Recheck the Head offset and Recognition Offset. Set the Head
offset and and Recognition Recognition Offset again if R-axis Origin Offset is incorrect.
Since eccentricity is Offset compensated by angle (30°), and the compensation should be
modified as the
reference angle is shifted.
ANC Teaching Where the reference marks are placed on the left and right of ANC, each
position is automatically entered when the reference mark positions
are entered. Where no mark is given, teach hole positions.
To Next Page
Loading...
