Miranda Kaleido-X16 - 2 Gateway Commands; Index of Gateway Commands

USER’S GUIDE
4 | Kaleido Remote Control Protocol (Gateway)
2 Gateway Commands
Kaleido multi-viewers support the following commands through the Gateway access. Most of these apply
to all Kaleido multi-viewer models, but some only apply to one platform, as indicated in the list.
Furthermore, there may be differences in the use or syntax of some commands depending on the
platform. All of these points are clarified in the detailed description of each command that follows.
Note: All gateway commands must be followed by a carriage return. In scripts, add \n at the end of each
gateway command.
2.1 Index of Gateway Commands
The applicable Kaleido systems are indicated as follows:
Code
System
Multi-Viewer Models
KX
Kaleido-X Software
Kaleido-X, Kaleido-X16, KMV-3901/3911, Kaleido-IP
K2
Kaleido-K2 Software
Kaleido-K2
AQ
Kaleido-Alto/Quad/Quad-Dual
Kaleido-Alto, Kaleido-Quad, Kaleido-Quad-Dual
The star () symbol indicates a new command, or a command with new parameters.
Command
Applies to
Description
Page
openID
KX
K2
AQ
Opens a session with the specified Kaleido
6
closeID
KX
K2
AQ
Closes a previously opened session
7
getParameterInfo
KX
Gets the system name, or its software version
8
getKCurrentLayout
KX
K2
AQ
Gets the name of the current layout
8
setKCurrentLayout
KX
K2
AQ
Loads a specific layout
9
getKLayoutList
KX
K2
AQ
Gets the list of available layouts
9
getKRoom
KX
Gets information on how the heads are
positioned within the specified room
10
getKRoomList
KX
Gets the list of available rooms
12
setKStatusMessage
KX
K2
AQ
Sets a Gateway alarm to the specified state
12
setKUnlatch
KX
Acknowledges the global alarm for the specified
source (channel)
13
getKChannel
KX
Gets the source (channel) currently assigned to
the specified monitor
13