Miranda KMV-3901 - Page 16

USER’S GUIDE
12 | Kaleido Remote Control Protocol (Gateway)
getKRoomList KX
This command is used to obtain the list of rooms known to your multi-viewer system.
<getKRoomList/>
Gateway response:
 <kRoomList><room>Room A</room><room>Room B</room></kRoomList>
 <nack/>: The Gateway was not able to recognize the command.
setKStatusMessage KX K2 AQ
This command associates an Alarm state with an ID. The Kaleido can be configured to listen to
alarm status messages from the Gateway, and thus report the state it receives. This is a
convenient way of reporting Alarms to the Kaleido.
<setKStatusMessage>set id="ID" status="Status"
message="Message"</setKStatusMessage>
Where:
o ID is the identifier that will receive the new state.
Note: Kaleido-Alto/Quad/Quad-Dual will only accept numeric values for this parameter,
in the range 0 to 1024. The Kaleido-K2 and Kaleido-X series do not have this limitation.
o Status is any of the available statuses:
Status
Alternate (legacy)
status
Kaleido-X Series
Kaleido-K2/Alto/Quad/Quad-Dual
DISABLE
DISABLE
Disabled
Disabled
NORMAL
OK
Normal
OK
MINOR
WARNING
Minor
Warning
MAJOR
MAJOR
Major
(not supported)
CRITICAL
ERROR
Critical
Error
o TheMessage is reserved for future use, and is ignored.
Gateway response:
 <ack/>: The command was recognized by the Gateway.
 <nack/>: The Gateway was not able to recognize the command.