USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 13
setKUnlatch KX
This command is used to acknowledge the global alarm for a given source (channel). It can also
be used to acknowledge specific alarms.
The command supports three parameter types: channelName, id or uri:
o If channelName is specified, the global alarm associated with the specified source
(channel) will be acknowledged.
o If uri is specified, the alarm with the specified URI will be acknowledged.
o If id is specified then the gateway alarm with the specified ID will be acknowledged.
Note: Only one parameter can be specified, otherwise the Gateway will return <nack/>.
<setKUnlatch>set channelName="ChannelName"</setKUnlatch>
<setKUnlatch> set uri="AlarmURI"</setKUnlatch>
<setKUnlatch>set id="AlarmName"</setKUnlatch>
Gateway response:
<ack/>: The command was recognized by the Gateway.
<nack/>: The Gateway was not able to recognize the command.
Examples:
o <setKUnlatch>set channelName="/Input A/Channel 01"</setKUnlatch>
o <setKUnlatch>set
uri="miranda.monako.daq://local/data/master/3/card/av1/DTVCCData#dt
vccService1Presence"</setKUnlatch>
o <setKUnlatch>set id="my_gateway_alarm_1"</setKUnlatch>
getKChannel KX
Note: This command is currently supported on the Kaleido-IP multi-viewer models only.
This command is used to obtain the logical source (channel) currently assigned to the specified
monitor in the current layout.
<getKChannel>set monitor="MonitorName"</getKChannel>
Where MonitorName is the name of the monitor whose source you wish to obtain. The monitor
name must be prefixed with the room name and a “/” if the session does not have a room context.
Ex.: Room1/composite42. The monitor name is available in the XEdit layout (see Name, under
Assignments in the Properties tab).
Gateway response:
<kChannel>channelname="ChannelName"</kChannel>
To Next Page
