Miranda KMV-3901 - Page 26

USER’S GUIDE
22 | Kaleido Remote Control Protocol (Gateway)
o BB indicates the group. Valid values range from 1 to 4.
o X indicates the AES. Valid value can be either 1 or 2.
To stop audio monitoring and mute the audio output:
<setKAudioOut>set Type="NONE"</setKAudioOut>
Gateway response:
 <ack/>: The command was correctly interpreted.
 <nack/>: The command was not executed, due to wrong spelling or an invalid parameter.
Note: You may select any audio source for monitoring, independent of whether it is being
metered in the current layout, with the exception that a streaming source must be part of the
current layout.
 If the source is included in the layout, the meter assigned to it will be highlighted.
 If the source is not included in the layout, the sound will be routed to the audio monitors, but
there will be no indication of the source, in the layout.
getKAudioOutVolume KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 and Kaleido-IP models.
This command retrieves the audio monitoring volume currently used.
<getKAudioOutVolume/>
The returned value will have the form:
 <kAudioOutVolume>volume="XX"</kAudioOutVolume>
Where XX is the value, expressed in dB, at which the audio monitoring volume is set. This
value ranges between -96 dB and +24 dB for a Kaleido-X series multi-viewer, and
between -90 dB and 0 dB for a Kaleido-K2/Alto/Quad/Quad-Dual. Fractions of dB are
supported on the Kaleido-X series multi-viewers only.
 <nack/>: The command was not recognized.
setKAudioOutVolume KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 and Kaleido-IP models.
This command sets the audio monitoring volume.
<setKAudioOutVolume>set volume="XX"</setKAudioOutVolume>
Where XX is the value expressed in dB at which the volume will be set. Valid values range
between -96 dB and +24 dB for a Kaleido-X series multi-viewer, and between -90 dB and 0 dB for