Miranda KMV-3901 - Page 27

USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 23
a Kaleido-K2/Alto/Quad/Quad-Dual. Fractions of dB are supported on the Kaleido-X series multi-
viewers only.
Note: If the audio signal is muted, executing this command will unmute the signal.
Returned value will be one of:
 <ack/>: The command was correctly interpreted. The volume was set to the new value.
 <nack/>: The command was not executed, due to a spelling error or invalid parameter.
The volume remains unchanged.
getKAudioOutMode KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 and Kaleido-IP models.
This command retrieves the audio monitoring mode currently used.
<getKAudioOutMode/>
Returned value will have the form:
 <kAudioOutMode>mode="XXXXX"</kAudioOutMode>
Where XXXXX is the mode, which can be any of NORMAL, MUTE or –20 dB.
 <nack/>: The command was not executed, due to a spelling error or invalid parameter. In
this case the audio monitoring mode remains unchanged.
setKAudioOutMode KX K2 AQ
Note: This command is currently not supported on the KMV-3901/3911 and Kaleido-IP models.
To set the Audio Monitoring Mode the following command is used:
<setKAudioOutMode>set mode="XXXXX"</setKAudioOutMode>
Where XXXXX is the value at which the mode must be set. Valid values are NORMAL, MUTE
and –20 dB.
Returned value will be any of:
 <ack/>: The command was correctly interpreted. The Audio Monitoring Mode was set to
the specified value.
 <nack/>: The command was not executed, due to bad spelling or invalid parameter. The
Audio Monitoring Mode remains unchanged.