USER’S GUIDE
24 | Kaleido Remote Control Protocol (Gateway)
setKVerticalOffset AQ
This command is used to position the CPU’s graphic output vertically within the final DVI output
on the display. The Kaleido-Alto/Quad’s CPU includes up to 1024 lines, whereas the final output
includes up to 1200 lines.
<setKVerticalOffset>set offset="NN"</setKVerticalOffset>
Where NN is the number of lines (between 0 and 175) by which to offset the CPU’s graphic
output, from the top of the final DVI output.
Gateway response:
<ack/>: The command was recognized by the Gateway.
<nack/>: The Gateway was not able to recognize the command.
setKIcontrolMode AQ
This command is used to enable the Kaleido-Alto/Quad to key the detected mouse pointer colors
on video.
<setKIcontrolMode>set mode="N"</setKIcontrolMode>
Where N is either 0 (color not keyed), or 1 (color key enabled).
Gateway response:
<ack/>: The command was recognized by the Gateway.
<nack/>: The Gateway was not able to recognize the command.
setKMouseColorA AQ
This command is used to set a color to key.
<setKMouseColorA>set mouseColorA="FFBBGGRR"</setKMouseColorA>
Where FFBBGGRR is the hexadecimal triplet for mouseColorA prefixed with the hexadecimal
value “FF”.
BB represents the blue component.
GG represents the green component.
RR represents the red component.
For example "FFFF00FF" would set magenta as the key color.
Gateway response:
To Next Page
