Mirka® Dust Extractor • 1230 M & 1242 M • 230 V / 100–120 V • PC & AFC 95
en
Turn to I: Activate the dust extractor.
Turn clockwise for speed control.
Turn to 0: Stop the dust extractor.
Turn to sander: Activate Auto-On/Off.
Operation – turn counter-clockwise for speed control.
Turn to I: Activate the dust extractor.
Turn to
: Stop the dust extractor. Permanent power on socket.
Turn to I: Activate Auto-On/Off operation.
Turn to I + AFC Off: Activate the dust extractor with deactivated Auto Filter Cleaning.
Turn to sander + Off: Activate Auto-On/Off operation with deactivated Auto Filter Cleaning.
Speed control operation on separate rotary knob.
The hose diameter and the setting for suction hose diameter must be the same: Ø 21, 27, 32, 36, 38 mm.
3.2 Auto-On / Off socket outlet for power tools
CAUTION
Appliance socket
The appliance socket is designed for electrical auxiliary equipment; see technical data for reference.
• Prior to plugging in an appliance, always switch off the machine and the appliance that is to be connected.
• Read the operating instructions for the appliance to be connected and observe the safety notes contained in these.
An earthed appliance socket is integrated in the machine. An external power tool can be connected there. The socket
features permanent power on when the switch is set to the
position, i.e. the machine can be used as an extension
cord.
In position
, the machine can be switched on and off from the connected power tool.
Dirt is picked up from the source of dust immediately. To comply with regulations, only approved dust-producing tools
should be connected.
The maximum power consumption of the connected electrical appliance is stated in the “Specifications” section.
Before turning the switch to position
, ensure that the tool connected to the appliance socket is switched off.
3.3 Push & Clean
The “PC” machine is equipped with a semiautomatic filter cleaning system, Push & Clean. The filter cleaning system must
be actuated when the suction performance starts to fade. Regular use of the filter cleaning feature maintains suction
performance and increases the lifetime of the filter. For instructions, see the quick reference guide.
3.4 AFC – Auto Filter Cleaning
The “AFC” machine is equipped with an automatic filter cleaning system, Auto Filter Cleaning. A frequent cleaning cycle
will automatically run during operation to ensure that suction performance is always at its best.
If suction performance decreases or in very dusty applications, a manual filter cleaning operation is recommended:
• Switch off the machine.
• Close the nozzles or suction hose opening with the palm of your hand.
• Turn the switch to position “I” and let the machine operate at full speed for approx. 10 seconds with the suction hose
opening closed.
If suction power is still reduced take out the filter and clean it mechanically or replace the filter. For certain applications,
such as wet pick-up, it is recommended to turn off the Auto Filter Cleaning system. For details see chapter 3.1.
To Next Page
