52
OPERATING INSTRUCTIONS
model
BM 155
TROUBLE SHOOTING GUIDE
Problem Cause Solution
Smoke from ventilation
hole when baking
Some ingredients adhere to the heat
element or nearby during the first use,
oil remained on the surface of the heat
element.
Unplug the bread maker and clean the heat
element, but be careful not to burn your-
self, let it run dry then.
Bread bottom crust is too
thick
The bread is kept warm in the bread
pan for a long time, which results in
a considerable loss of water.
Take bread out soon without keeping it
warm.
It is very difficult to take
bread out
The kneader adheres tightly to the
shaft in bread pan.
After taking the bread out, put hot water
into the bread pan and let the kneader soak
for around 10 minutes, then take it out and
clean.
The ingredients are poorly
stirred and baked
The selected menu program is im-
proper.
Select the proper program menu.
The lid was opened several times
during the operation, which led to
the bread being dry and lacking a
brown crust.
Do not open the lid until the bakery is
ready.
Stir resistance is too large so the
kneader cannot rotate and stir
properly.
Check the kneader hole, then take the bread
pan out and operate without load. If the
problem is not fixed, contact the authorized
service center.
The motor noise is heard but
the dough is not stirred
Bread pan is fixed improperly or
dough is too large to be stirred.
Check whether the bread pan is fixed prop-
erly, the dough is made according to the
recipe and the ingredients are weighed ac-
curately.
The bread is too large to
take it out.
The amount of yeast, flour or water
is excessive, or the temperature in
the room is too high.
Check these factors and reduce the
amount of ingredients according to the
instructions.
Bread size is too small or
bread has no rise
No yeast or the amount of yeast is
not sufficient, moreover, yeast may
have a poor activity as water tem-
perature is too high or yeast is mixed
together with salt, or the environ-
ment temperature is lower.
Check the amount and performance of
yeast, increase the environment tempera-
ture properly.
To Next Page