I
Loudspeaker
Instruction Manual English
I
Congratulations
on your choice of loudspeakers. Your MISSION Your loudspeakers are precision manufactured
and
in the interest
loudspeakers are
precision manufactured products using the latest of sound quality they are not electrically
protected. For
long term
computer
controlled technology
and have been matched and
satisfaction and optimum performance
it is strongly
recommended
tested to the
highest standards to give years of trouble - free that special care and attention be paid
to the following
points.
peorgaqe"
A feévr gigtuts Spemnsin
studying this instruction
DO NOT change any component
in your system
without first
man“ W enswe e
a mg res“ ‘
switching off your amplifier. Eveiy
time you
change connections
of
tape
decks, tuners, turntables,
compact disc
players, etc.
to your
|MPoR-I-ANT
amplifier,
ensure that
you first SWITCH OFF
the amplifier.
DO
NOT use your amplifier
at maximum power.
This will
'clip‘ the
RUNMNG ' ‘N
PERIOD
amplifier and damage
your loudspeakers.
gag/ETSNEJQEINS.P:gg2T‘[%’°J§SDPE%)<EggRgV%T€€lC§J1:MgH5
When switching on your system,
turn the volume
control down for
THAT
FOR OPTMUM PERFORMANCE
TH'E LOUDSPEAKERS
a few
seconds as some
amplifiers put
a ‘thump’
through the
SHOULD BE RUN IN FOR
A
PERIOD
OF 1o HOURS BEFORE
'°“dsPeake's
‘"h'°“ Ca“ °a“S° damage-
FINAL POSITIONING. When changing records, re-dialling
tuners,
rewinding tapes,
turn
the
volume control down
to its minimum.
DO NOT use the filters,
tone controls or
graphic
equalisers on
THE WSSION
CYRUS GROUP
your amplifier.
These
are nearly
always detrimental
to the
The MISSION
CYRUS GROUP manufactures products under the accurate reproduction of music and
should be set
at '0‘.
m'SS'ONC8§gG'RUSaP'a."d
gages"
when
we refer“)
M|SS'ON' DO _N_OT expose your
loudspeakers
to excessive
cold, heat,
e word
S '5 3° mp
humidity
or sunlight
- see Maintenance.
DO NOT connect
your loudspeakers
to the
mains electricity
supply.
It is imperative that your loudspeakers
are
correctly wired
and are
in phase
- see Connecting
your loudspeakers.
DO NOT use lengths of
loudspeaker cable
joined together.
DO NOT mount your
loudspeakers
by the rear
panel. Wall
brackets, if used, must support
the underside of
the product.
DO NOT dispose of the packing
materials for
your loudspeakers
as you may wish to transport
them at
some future
date. Correct
packing will ensure that they can
be shipped
without damage.
To Next Page
Loading...
