Mistral MSF1835 - Operating Instructions; How to adjust the height; Timer knob; Key Switch

220-240～
50/60Hz
Timer knob When the fan is on,turn in clockwise
direction to the time you want the fan
turn off in automatically.
Key Switch Press 1 ,2 or 3 to choose the desired
speed,Press 0 to turn off the fan.
Loosen the connecting rod(13) anticlockwise and
enable to adjust the height of slide pipe(12).
Tighten the connecting rod(13) clockwise after
adjusting to the desired height.
0
1
3
2
0------------OFF
2------------Med speed
3------------High speed
1------------low speed
SWAY Press sway tube(7) down to sway,
pull sway tube(7) up to stop sway.
60
20
ON
40
OFF
Appearance may vary
10
30
50
5.Installing the front guard
① Loosen the screw on the guard ring(2).(see Figure 8)
② Align the front guard(1) with the rear guard(5). Buckle the outer ting of the front guard(1) and the
rear guard(5) into the goove of the guard ring(2).(see Figure 9)
③ Tighten the guard ring screw.(see Figure 10)
④ Engage the clip.(see Figure 10)
Fig. 8
Fig. 9
Fig. 10