Mistral MWVC552 - First Use; Operation

6
First Use
Checking the product and scope of delivery if you
are not cautious when opening the packaging
with a sharp knife or other pointed object, you
may quickly damage the product.
• For this reason, be very careful when opening it.
1. Take the product out of the packaging.
2. Check to make sure that all parts are included.
3. Check whether the product or individual parts
are damaged. If this is the case, do not use the
product.
Basic cleaning
• Remove the packaging material and all
plastic wrappings.
• Clean all parts of the product before rst use
as described in the chapter “Cleaning”.
Operation
Charging the product
Caution: before using the product, the baery has
to be fully charged.
Do not turn on the product during charging.
Note:This product must be used only
with the baery charger provided with
the product CZH015270050AUWH.
• To maintain a charge, keep the charger
plugged into a standard a 230V — 240V power
outlet. Ideally, A full charge cycle takes about
5 hours. A partial charge will reduce the
service time. The charging adapter and the
top of the appliance may become hot during
the charge – this is normal.
• Once a single line of the baery level indicator
flashes, turn o the product and connect the
electric plug of the baery charger to a power
outlet and the plug into the socket on the side
of the baery.
• The three charging lines will light up in
sequence and the blue light placed near the
plug connection on the baery will flash.
• At the end of the recharge, the three lines will
all be illuminated and the light near the plug
connection on the baery will be blue and not
flashing.
• Full recharge in about 5 hours – about 20
minutes working time in high speed – about 30
minutes working time in low speed.
• The baery can be recharged either aached
to the Main Unit or detached from it. To detach
the baery from the Main Unit, press the
baery release buon and remove it. (Fig.1)
Fig.1
• To reposition the baery under the Main Unit,
insert the baery into the grooves until you
hear a click. (Fig.2)
Parts Assembly
Baeries Unit
Insert the baeries unit into the boom of the
machine and when it locked into the machine,
you will hear the sound of connection. Pay
aention to the direction. (Fig.2)
Fig.2
Dust cup assembly assembled with the
Main unit
Connect the Main unit to the dust tank by aligning
the arrow placed on the lower part of the motor,
to the symbol and by holding the tank turn the
Main unit anticlockwise until you hear a click and
the arrow is aligned to the symbol . (Fig.3)
Fig.3