RS 232 communication
PS-Data April 29
th
2013 Page 4
3. Mita - WP3000
The following parameters have to be set to get a WP3000 working.
• Baud rate
• Handshaking
• Modem handling
• Id number
Normally is all communication done via com4 and the default setting is 9600 Baud. A WP3000
always uses 8 data bits, no parity and 1 stop bit (8N1)
To be able to change parameter is it necessarily to login.
Arrow down (4 times) to select
Press enter to select “Access rights”
Enter the password and accept with the enter key
Use the arrow keys to select “Request active-stat.”
Press enter and key in a user id 123 and accept with the enter key
The computer should now be in access level 99 and active.
The menu can be toggled by using the arrow keys left and right.
Use Esc to go out of a sub menu.
Use enter to accept a new input.
Use DEL to erase a value (The cursor must be to the left of the value)
To remove the access level 99 select the start menu and use the arrow keys to select the “Access
rights line” and press enter two times.
To remote the active-state select the “Release Active-state” and press enter one time.
To Next Page
Loading...
Need help?
General