MIVOICE 4420 IP BASIC (DBC 420) FOR MIVOICE MX-ONE
21 9/1553-ANF 901 54 Uen L1 2016-03-09
4.11 RE-DIALING NUMBERS
4.11.1 RE-DIALING THE LAST EXTERNAL NUMBER
1) Lift the handset (dial tone).
2) Dial *** while in idle state or with dial tone. The last dialed external number is
automatically re-dialed.
4.12 NAME AND NUMBER LOG
Note: Not applicable.
4.13 AUTHORIZATION CODE
4.13.1 GENERAL
To each authorization code a Call Information Logging (CIL) code is affiliated. The CIL
code is used as the calling party's identity.
To each authorization code a common category or common service profile is affiliated.
This is the category or service profile which is used, instead of the extension's, when a
call is made using an authorization code.
Authorization code is divided into two different functionality groups:
• Common authorization code
This is a code that does not have to be affiliated to any directory number in the
system. The authorization code can however be limited to one telephone. The
authorization code cannot be changed by the user.
The common authorization code provides two different functions:
– Locking/unlocking of an extension. When locked a lower common cate-
gory code or common service profile is used.
– Authorization code dialing. This enables the calling party to use other cate-
gories or service profiles than those the extension is programmed with.
• Individual authorization code
This is a code that is always affiliated to a directory number in the system.
The individual authorization code provides three different functions:
– Locking/unlocking of an extension. When locked a lower common service
profile is used.
– Authorization code dialing. This enables the calling party to use other cate-
gories or service profiles than those the extension is programmed with.
– Changing the authorization code from the phone. This enables the autho-
rization code user to change the code when suitable.
Using Last Number Re-dial on external calls after dialing with common/individual
authorization code: