Page 32
1 - The load bar is bent when closing :
- Check that the fabric is well centered with respect to the guide.
- The rope comes off a pulley. Go through the entire rope route to nd the location.
- The tension of one string is higher than the other. Check that the tension is identical on both sides.
- Incorrect squaring.
3 - The fabric is slack :
- Incorrect system voltage. Stop the opening of the fabric at the level of the lack of tension and tighten the fabric.
4 - Opening and closing impossible with functional electrical operation :
- Rope breakage. Check the complete route of the rope.
5 - The electrical maneuver no longer works :
- The motor enters thermal protection after 4 minutes of operation. Wait for the end of the thermal protection (20 minutes).
- Reprogram the remote control.
- Make sure the motor is running.
- Check the motor connection. Attention, cut off the power in case of manipulation.
A fabric pergola is subject to many restrictions: humidity, salty air, weight restriction, wind, etc.
Therefore, we recommend :
check the screws and limit switches after installation, then regularly: at the beginning and end of the season.
never leave the wet fabric rolled up. Dry as soon as possible.
clean the fabric and the frame at the beginning and at the end of the season. Be careful not to use detergent.
Maintenance tips for your fabric pergola.
Do not unroll the fabric in case of :
rain
Wind
snow
Do not hang anything
FAQ
To Next Page
Loading...