Upon arrival, inspect the product packaging and helmet and
carefully check whether any items were damaged during
transportation.
Keep the package for future use.
Insert the USB end of the data cable into the charger interface
and the type-C interface end into the charging input port of
the remote control (as shown on the next page).
After the charger is powered on, start charging. The battery
mark in the upper right corner of the remote control displays
the power.
After being fully charged, the power displays 4 grids, and then
stop charging.
1. To control or adjust the laser helmet device or to perform each
step of the operation other than those specified in the operating
instructions, may cause hazards such as possible harmful
radiation, electric shock, fire or malfunction.
2. It is recommended to use the laser helmet 3-4 times a week.
The recommended session time is 20 minutes, and the next s can
be carried out after an interval of 24 hours.
Step 1: Unpack!
Step 2: Charge
How to use
20
Warning
To Next Page
Loading...