Mitox 25C SELECT - Hot Engine Starting; Stopping the Engine

25C SELECT Grass Trimmer
19
Original Instructions Version June 16
llow the engine to warm up before use. When cutting, always use the grass trimmer on
full throttle.
Hot Engine Starting
• Set the ignition switch to the STRT ( I ) position.
• Check the clear return fuel line. If the line is empty, push the air purge bulb until fuel is
visible in the clear return fuel line.
• Move the choke lever to the STRT( ) position, then back to the RUN ( )
position. This will set the throttle to the hot start position.
• Pull the starter rope until the engine starts, then squeeze the throttle briefly to release
the fast idle control and return the engine to idle.
• If the engine does not start after 5 pulls, use the Cold Start procedure.
Overchoking
Should the engine become flooded due to overchoking, turn the ignition switch o, unscrew the
spark plug, wipe it dry or replace.
Stopping the Engine
Set the engine to idling by releasing the throttle lever.
Set the ignition switch to the o position ‘’O’’ (STOP).
If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use
the machine until the ignition switch is repaired.
NOTE
Fig 6 - Pull the starter rope until the engine
starts, then squeeze the throttle briefly to
release the fast idle control and return the
engine to idle.
Fig 5 - Move the choke lever (e) to the
RUN ( ) position.
ST
ART
RUN
ONCE RUNNING:
W
A
IT 6-10 SECONDS,
SQUEEZE THROTTLE.
HOT ST
A
RT:
STOP
SWITCH
‘O’
1
2
STOP
3
5
PRIME x7
CHOKE ST
ART PULL UNTIL FIRE
CHOKE RUN PULL TO RUN
COLD
ST
A
RT:
(e)