Never hold the Multi-Tool in a way in which the cutting head is pointing towards someone else.
Never allow the blades to come into contact with your body.
Always turn o the engine before adjusting the Multi-Tool, or at any time when coming into close proximity
with the cutting head.
Always wear thick work gloves when adjusting the Multi-Tool.
Safe Handling of Fuel
The engine of the Multi-Tool is designed to run on a two stroke oil/fuel mixture.
This fuel is highly ammable; never store cans of fuel or rell the fuel tank in any place where there is a source
of heat or re, which might ignite the fuel.
Do not smoke whilst operating the Multi-Tool or relling, keep lit cigarettes away from the Multi-Tool at all
times.
When relling the fuel tank always stop the engine rst and carefully make sure that there are no sparks or
naked ames anywhere nearby before refuelling.
If any fuel spillage occurs during refuelling, use a dry rag to wipe any fuel which has been spilled onto the
Multi-Tool before starting the engine.
After refuelling, screw the fuel cap back tightly onto the fuel tank and carry the Multi-Tool to a spot 5 metres
or more away from where it was refuelled before starting the engine.
To Next Page
Loading...
