Mitox 28PP - Troubleshooting; Service Schedule

28PP Pole Pruner
27
Original Instructions Version December 15
Service Schedule
Component Procedure Before
use
Every
15
Hours
Every
25
Hours
Every
50
Hours
Note
Engine
Fuel leaks / spillage Wipe up
Fuel tank, filter Inspect /
clean
X
Replace if nec-
essary
Idle adjust screw See above
X X
Adjust carburet-
tor if necessary
Spark plug LD L8RTF;
CHAMPION RCJ7Y;
NGK BPMR7A
Clean and
readjust
plug gap
X
GAP .025” (0.6-
0.7mm)
Replace, if
necessary
Cylinder fins, Intake
air cooling vent
Clean
X
Air filter Clean
X
Muer, Spark arres-
tor, cylinder exhaust
port
Clean
X
Shaft
Throttle lever, ignition
switch
Check
operation
X
Screws, nuts, bolts Tighten /
replace
X
Not adjustment
screws
Gear Case Check X
Pole Pruner
Oiling Port Clean X
Guide Bar Clean X
Sprocket Inspect/
Replace
X
Saw Chain Inspect/
Replace
X
Troubleshooting
Engine will not start, power loss:
• Check that the fuel tank is not empty. Fill with mixed fuel.
• The fuel does not reach the carburettor. Change the fuel filter in the fuel tank.
• There is water in the fuel. Drain and clean the fuel system.
• The air filter is dirty. Clean or replace the air filter.
• There are carbon deposits in the exhaust muer restricting the engine. Clean or change the muer.
• Spark plug is worn. Replace spark plug.