FITTING THE NYLON HEAD
Screw the nylon head anti-clockwise
(turn left) onto the threaded shaft at the
end of the gear case. Keep the shaft
locked in place by inserting a
screwdriver or hexagonal key through
the hole in the upper blade clamp and
tighten securely.
Make sure that the nylon head is
securely and safely locked in position.
FITTING THE 3 TOOTH BLADE
Remove split pin, unscrew the nut
clockwise (turn right) and remove the
lower blade clamp.
Place the 3 tooth blade on the upper
blade clamp, centring the centre of the
blade on the raised boss of the upper
blade clamp.
Replace the lower blade clamp in order
to secure the blade. Refit washer.
Screw the nut anti-clockwise (turn left)
using the tool provided.
Tightening torque: 30 Nm or 3 Mkg.
Make sure that the blade is completely
and safely locked in position. Refit
split pin.
The blade MUST be
correctly positioned on the upper
blade clamp otherwise SERIOUS
DAMAGE AND INJURY TO
PERSONS AND PROPERTY could
result.
HEX ke
To Next Page
Loading...
