To Next PageTo Next PageWhat to do if CRC error occurred in Mitsubishi Electric Circuit breakers?
If a CRC error occurs with your Mitsubishi Electric Circuit Breakers, first, verify that the CC-Link cable type, overall distance, station-to-station distance, and terminal resistor are within the specified range. Next, check the CC-Link cable for wire breakage, shorts, or reversed connections. Finally, ensure the FG terminal of the BIF-CC is properly grounded.
What to do if a hardware error occurred in Mitsubishi Electric Circuit breakers?
If a hardware error has occurred with your Mitsubishi Electric Circuit Breakers, you should first check for an internal transmission error. You may also check the power supply of the power supply module (P1-P5). Also, check for any wire breakage in the internal transmission cable, and ensure that the internal transmission cable is wired properly.
What to do if internal transmission error occurred in Mitsubishi Electric Circuit breakers?
If an internal transmission error has occurred with your Mitsubishi Electric Circuit Breakers, check the power supply of the Power supply module (P1-P5). Also, check that there is no wire breakage in the internal transmission cable, and ensure that the internal transmission cable is wired properly.
What to do if the setting data set by setting command is outside the range for Mitsubishi Electric Circuit breakers?
If the setting data set by setting command is outside the range for your Mitsubishi Electric Circuit Breakers, correct the setting data, and send data again.
What to do if the command number is outside the range for Mitsubishi Electric Circuit breakers?
If the command number is outside the range for your Mitsubishi Electric Circuit Breakers, correct the command number and send data again.
What to do if the data group number is outside the range for Mitsubishi Electric Circuit breakers?
If the data group number is outside the range for your Mitsubishi Electric Circuit Breakers, correct the data group number and send data again.
What to do if the unit number is outside the range for Mitsubishi Electric Circuit breakers?
If the unit number is outside the range for your Mitsubishi Electric Circuit Breakers, correct the unit number and send data again.
What to do if hardware fault in Mitsubishi Electric Circuit breakers?
If you encounter a hardware fault with your Mitsubishi Electric Circuit Breakers, try switching the power off and then on again.
How to resolve invalid baud rate or station number setting in Mitsubishi Electric Circuit breakers?
To resolve an invalid baud rate or station number setting on your Mitsubishi Electric Circuit Breakers, check that the STATION NO. or B RATE switch is not outside the setting range.
General| Rated Current (In) | 1000 A |
|---|---|
| Rated Voltage (AC) | 690 V |
| Breaking Capacity | 50 kA |
| Trip unit | Electronic |
| Mounting | Fixed |
| Poles | 3P |
General and Modbus specifications for the BIF-MD unit.
General specifications for the optional BIF-CON unit.
Identifies physical components and indicators of the BIF-MD unit.
Details physical components and indicators of the BIF-CON unit.
Instructions for mounting BIF-MD/BIF-CON units on a 35mm IEC rail.
Instructions for installing units using a mounting bracket.
Defines the components of a standard Modbus communication frame.
Illustrates the bit sequence used in Modbus RTU framing.
Explains Modbus RTU message framing for reliable transmission.
Details Modbus query/response message structure for specific function codes.
Lists and explains Modbus exception codes and meanings.
Comprehensive list of Modbus register addresses and functions.
