To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric CITY MULTI PURY-P234TGMU-A and is the answer not in the manual?
General| Brand | Mitsubishi Electric |
|---|---|
| Model | CITY MULTI PURY-P234TGMU-A |
| Category | Air Conditioner |
| Language | English |
Essential safety guidelines and warnings before installing or servicing the unit to prevent injury or death.
Specific safety measures and precautions when working with R410A refrigerant and related components.
Important considerations and warnings before proceeding with the installation of the unit.
Guidelines for performing electrical work, including grounding, wiring, and safe handling during installation.
Crucial steps and precautions to take before conducting the initial test run of the unit.
Compares functions and specifications of MA and M-NET (ME) remote controllers, and provides selection criteria.
Procedures for group settings and interlock settings with LOSSNAY units using the ME remote controller.
Steps for performing LOSSNAY interlock settings, searching, and deleting interlock configurations.
Provides detailed electrical wiring diagrams for PUHY and PURY outdoor units across various models.
Illustrates electrical wiring diagrams for different BC controller models (CMB-P104NU-G, CMB-P105NU-G, etc.).
Details the functions and factory settings of dipswitches (SWU, SW1, SW2, SW3, SW4, SW5) on the outdoor unit.
Explains initial control, start-up control, bypass control, and compressor frequency control for PUHY and PURY units.
Describes the logic for starting, stopping, and handling problems during defrost operations for PUHY and PURY units.
Pre-test run checks including refrigerant leak, insulation resistance, valve status, and phase sequence.
Step-by-step guide on how to perform a test run using the MA deluxe remote controller.
A comprehensive list of error codes, their definitions, and the affected units (outdoor, indoor, BC controller, etc.).
Procedures for identifying and repairing refrigerant leaks in extension pipes and outdoor units during cooling/heating.
Comprehensive table mapping SW settings to display codes (LD1-LD8) for monitoring unit status and errors.
