Models : MELSEC FX2N series manufactured
from July 1st, 1997 FX2N-ËËER-ES/UL FX2N-ËËET-ESS/UL
Where ËË indicates:32,48
FX2N-16EX-ES/UL FX2N-16EYR-ES/UL
FX2N-16EYT-ESS/UL
from April 1st, 1998 FX2N-48ER-DS FX2N-48ET-DSS
from August 1st, 1998 FX2N-48ER-UA1/UL
from August 1st, 2005 FX2N-8ER-ES/UL FX2N-8EX-ES/UL
FX2N-8EYR-ES/UL FX2N-8EYT-ESS/UL
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with EN50081-2 (EN61000-
6-4) and EN50082-2
from April 1st, 2002 to April 30th, 2006 are compliant with EN50081-
2 (EN61000-6-4) and EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2003
Requirement for Compliance with LVD directive
The following products have shown compliance through direct
testing (of the identified standards below) and design analysis
(through the creation of a technical construction file) to the European
Directive for Low Voltage (2006/95/EC) when used as directed by
the appropriate documentation.
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX3G series manufactured
from November 1st, 2008 FX
3G-ËËMT/ES(-A)
Where ËË indicates:14,24,40,60
from December 1st, 2008 FX
3G-ËËMR/ES(-A)
Where ËË indicates:14,24,40,60
from March 1st, 2009 FX3G-ËËMT/ESS
Where ËË indicates:14,24,40,60
from December 1st, 2009 FX
3G-ËËMR/DS
Where ËË indicates:14,24,40,60
Models :MELSEC FX
2N series manufactured
from July 1st, 1997 FX
2N-ËËER-ES/UL FX2N-ËËET-ESS/UL
Where ËË indicates:32,48
FX2N-16EYR-ES/UL
from April 1st, 1998 FX2N-48ER-DS
from August 1st, 1998 FX2N-48ER-UA1/UL
from August 1st, 2005 FX2N-8ER-ES/UL FX2N-8EYR-ES/UL
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-
2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2003
Standard Remark
EN61000-6-4:2007
- Generic emission
standard
Industrial environment
EN50081-2:1993
Electromagnetic
compatibility
Compliance with all relevant aspects
of the standard.
• Radiated Emissions
• Mains Terminal Voltage Emissions
EN50082-2:1995
Electromagnetic
compatibility
- Generic immunity
standard
Industrial environment
Compliance with all relevant aspects
of the standard.
• RF immunity
• Fast Transients
• ESD
• Conducted
• Power magnetic fields
EN61131-2:1994
/A11:1996
/A12:2000
Programmable controllers
-Equipment
requirements and tests
Compliance with all relevant aspects
of the standard.
• RF Immunity
• Fast Transients
• ESD
• Damped oscillatory wave
EN61131-2:2003
Programmable controllers
-Equipment
requirements and tests
Compliance with all relevant aspects
of the standard.
EMI
• Radiated Emissions
• Conducted Emissions
EMS
• Radiated electromagnetic field
• Fast transient burst
• Electrostatic discharge
• High-energy surge
• Voltage drops and interruptions
• Conducted RF
• Power frequency magnetic field
Standard Remark
EN61131-2:2003
Programmable controllers
- Equipment
requirements and tests
The equipment has been assessed
as a component for fitting in a
suitable enclosure which meets the
requirements of EN61131-2:2003
Standard Remark
IEC1010-1:1990
/A1:1992
Safety requirements for
electrical equipment for
measurement, control, and
laboratory use
- General requirements
The equipment has been assessed
as a component for fitting in a
suitable enclosure which meets the
requirements of IEC 1010-1:
1990+A1:1992
EN61131-2:1994
/A11:1996
/A12:2000
Programmable controllers
- Equipment
requirements and tests
The equipment has been assessed
as a component for fitting in a
suitable enclosure which meets the
requirements of EN61131-2:
1994+A11:1996+A12:2000
EN61131-2:2003
Programmable controllers
- Equipment
requirements and tests
The equipment has been assessed
as a component for fitting in a
suitable enclosure which meets the
requirements of EN61131-2:2003
Caution for compliance with EC Directive
Installation in Enclosure
Programmable logic controllers are open-type devices that must be
installed and used within conductive control boxes. Please use the
FX
3G Series programmable logic controllers while installed in
conductive shielded control boxes. Please secure the control box lid
to the control box (for conduction). Installation within a control box
greatly affects the safety of the system and aids in shielding noise
from the programmable logic controller.
Associated manuals
FX3G Series PLC (main unit) comes with this document (hardware
manual).
For a detailed explanation of the FX3G Series hardware and
information on instructions for PLC programming and special
extension unit/block, refer to the relevant documents.
How to obtain manuals
For the necessary product manuals or documents, consult with the
Mitsubishi Electric dealer from where you purchase your product.
Incorporated Items
Check if the following product and items are included in the package:
*1 The FX3G-M/ES-A becomes Chinese version.
1. Outline
For the input/output extension units/blocks, refer to the following
manual.
→ Refer to FX3G Series User's Manual - Hardware Edition.
1.1 Part names
Manual name Manual No. Description
FX3G Series
User's Manual
- Hardware
Edition
JY997D31301
MODEL CODE:
09R521
Explains FX3G Series PLC
specification details for I/O,
wiring, installation, and
maintenance.
FX3G/FX3U/
FX3UC Series
Programming
Manual
- Basic & Applied
Instruction Edition
JY997D16601
MODEL CODE:
09R517
Describes PLC
programming for basic/
applied instructions STL/
SFC programming and
devices.
FX Series User’s
Manual - Data
Communication
Edition
JY997D16901
MODEL CODE:
09R715
Explains N:N link, parallel
link, computer link, no
protocol communication by
RS instructions/FX
2N-
232IF.
FX
3G/FX3U/
FX3UC Series
User's Manual
- Analog Control
Edition
JY997D16701
MODEL CODE:
09R619
Describes specifications for
analog control and
programming methods for
FX3G/FX3U/FX3UC Series
PLC.
FX3G/FX3U/
FX
3UC Series
User's Manual
- Positioning
Control Edition
JY997D16801
MODEL CODE:
09R620
Explains the specifications
for positioning control of
FX3G/FX3U/FX3UC Series
and programming
procedures
Included Items
Main units
FX
3G-14M~
FX3G-60M
Product 1 unit
Dust proof protection sheet 1 sheet
Manuals [Japanese version
*1
,
English version]
1 manual
each
Input/output extension units
FX2N-32E
,
FX2N-48E
Product 1 unit
Extension cable 1 cable
Input/output number label 1 sheet
Input/output extension blocks
FX2N-8E
FX2N-16E
Product 1 unit
Input/output number label 1 sheet
No. Name
[1] Peripheral device connecting connector cover
[2] Terminal names
[3] Top cover(S) (40points, 60points type only)
[4] Top cover
[5] Terminal block covers
[6] Input display LEDs (red)
[7] Extension device connecting connector cover
[2]
[5]
[7]
[8]
[1]
[11]
[6]
[3]
[4]
[10]
[9]
To Next Page
Loading...
