What to do if the parameter setting is illegal on my Mitsubishi Electric MELFA CR750?
If the parameter setting is illegal, as indicated in the error message's "(xxxxx)" part, you should check this parameter setting and set an appropriate value.
What to do if I haven't changed the initial password on my Mitsubishi Electric MELFA CR750 Controller?
If the password has not been changed from the initial value, you should change the password to a new one and perform parameter setting. Note that the factory default password is “MELFASafetyPSWD.”
What to do if the parameter CRC value is illegal on my Mitsubishi Electric MELFA CR750 Controller?
If the parameter CRC value is illegal, check the communication environment between the robot controller and the personal computer, and perform the writing operation again.
What to do if the duplex DSI status is not consistent on my Mitsubishi Electric Controller?
If the duplex DSI status is not consistent, check the DSI wiring, duplex signal ON/OFF status, ON/OFF status switching timing and parameter DSINO setting.
What to do if the SFMODE parameter setting is illegal on my Mitsubishi Electric MELFA CR750 Controller?
If the setting of the dedicated signal parameter SFMODE (safety mode output) is illegal, correct the parameter setting.
What to do if the extended safety unit is not connected to my Mitsubishi Electric MELFA CR750 Controller?
If the extended safety unit of the robot safety option is not connected, connect the extended safety unit. If the error occurs even if the extended safety unit is connected, the extended safety unit may be faulty. Contact your service provider.
What to do if the safety function enable/disable setting is inconsistent on my Mitsubishi Electric MELFA CR750?
If the enable/disable setting of the safety function is not consistent, turn the power OFF, then ON again. Then, check the enable/disable setting of the safety monitoring function. When the applicable robot is not compatible with the safety monitoring function, disable all the settings of the safety monitoring function.
What to do if position exceeds limit on Mitsubishi Electric Controller?
If a position in excess of the limit is detected by the position monitoring function, check the relevant parameter setting such as details of the robot movement or the definition of the plane.
What to do if torque error is detected on Mitsubishi Electric MELFA CR750?
If a torque error is detected by the torque width monitoring function, check the relevant parameter setting such as details of the robot movement, interference with the peripheral equipment, or the allowable torque width / terminal load setting.
What to do if excessive speed feedback is detected on Mitsubishi Electric MELFA CR750 Controller?
If an excessive speed feedback is detected by the speed monitoring function, check the robot movement or the monitoring speed setting. Or else, check that the reaction time (parameter SFREACT) setting is not too short.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MELFA CR750 Series |
| Category | Controller |
| Language | English |
To Next Page
