4 APPLICABLE FUNCTIONS
4.4 Touch probe [G]
237
4
■Details on [Touch probe status 2 (Obj. 2DE9h)]
Bit Description
0 0: Touch probe 3 disabled
1: Touch probe 3 enabled
1 0: The position at the rising edge of touch probe 3 has not been stored.
1: The position at the rising edge of touch probe 3 has been stored.
When the position feedback is stored in [Touch probe 3 positive edge (Obj. 2DEAh)] and the time stamp is stored in [Touch probe time stamp
3 positive value (Obj. 2DF8h)], "1" is set.
This bit is cleared to "0" when bit 4 of [Touch probe function 2 (Obj. 2DE8h)] is set to "0".
2 0: The position at the falling edge of touch probe 3 has not been stored.
1: The position at the falling edge of touch probe 3 has been stored.
When the position feedback is stored in [Touch probe 3 negative edge (Obj. 2DEBh)] and the time stamp is stored in [Touch probe time
stamp 3 negative value (Obj. 2DF9h)], "1" is set.
This bit is cleared to "0" when bit 5 of [Touch probe function 2 (Obj. 2DE8h)] is set to "0".
3 to 5 (reserved) The value at reading is undefined.
6 Toggle status for latch completion at the rising edge of touch probe 3
0 or 1: When bit 1 of [Touch probe function 2 (Obj. 2DE8h)] is set to "1" (continuous trigger mode), the status toggles between "0" and "1"
every time the position feedback is stored in [Touch probe 3 positive edge (Obj. 2DEAh)] and the time stamp is stored in [Touch probe time
stamp 3 positive value (Obj. 2DF8h)].
7 Toggle status for latch completion at the falling edge of touch probe 3
0 or 1: When bit 1 of [Touch probe function 2 (Obj. 2DE8h)] is set to "1" (continuous trigger mode), the status toggles between "0" and "1"
every time the position feedback is stored in [Touch probe 3 negative edge (Obj. 2DEBh)] and the time stamp is stored in [Touch probe time
stamp 3 negative value (Obj. 2DF9h)].
8 to 15 (reserved) The value at reading is undefined.
To Next Page
Loading...
