10 POSITIONING MODE (POINT TABLE METHOD) (CP) [G]
10.2 Point table mode (pt)
545
10
*1 When degree is set, the setting range is -360000 to 360000.
*2 In the linear servo motor control mode, the unit is mm/s.
*3 The setting unit of the speed and acceleration/deceleration can be changed using [Pr. PT01.1 Speed/acceleration/deceleration unit
selection].
*4 The setting value will be clamped at the maximum speed. When changing the speed to the permissible speed, set the speed in [Pr.
PA28.4 Speed range limit selection].
To Next Page
Loading...
