To Next PageTo Next PageWhy Mitsubishi Electric Mr. SLim PEAD-140JA Air Conditioner stops before reaching temperature?
During heating mode, the Mitsubishi Electric Air Conditioner may stop before reaching the set room temperature if the outdoor temperature is low and the humidity is high, which can cause frost to form on the outdoor unit. Normal operation should begin after approximately 10 minutes.
What to do if Mitsubishi Electric Mr. SLim PEAD-140JA won't turn on after turning off?
If you restart your Mitsubishi Electric Air Conditioner soon after stopping it, and it doesn't operate even when you press the ON/OFF button, wait approximately three minutes. Operation may have stopped to protect the air conditioner.
Why Mitsubishi Electric Mr. SLim PEAD-140JA warm air does not blow soon?
When heating operation starts, warm air does not blow from the indoor unit of your Mitsubishi Electric Air Conditioner until the indoor unit has sufficiently warmed up.
Why does my Mitsubishi Electric Mr. SLim PEAD-140JA turn off by itself?
If your Mitsubishi Electric Air Conditioner stops without pressing the ON/OFF button, check if the off timer is set and press the ON/OFF button to restart operation. Also, determine if the air conditioner is connected to a central remote controller, and if so, consult the people who control the air conditioner. Check if " " appears in the remote controller display, and if it does, consult the people who control the air conditioner.
Why does my Mitsubishi Electric Air Conditioner turn on by itself?
If your Mitsubishi Electric Air Conditioner operates without pressing the ON/OFF button, check the following: * Is the on timer set? If so, press the ON/OFF button to stop operation. * Is the air conditioner connected to a central remote controller? Consult the concerned people who control the air conditioner. * Does " " appear in the remote controller display? Consult the concerned people who control the air conditioner. * Has the auto recovery feature from power failures been set? If so, press the ON/OFF button to stop operation.
What does error code mean on my Mitsubishi Electric Mr. SLim PEAD-140JA Air Conditioner?
If an error code appears in the remote controller display of your Mitsubishi Electric Air Conditioner, it means the protection devices have been activated to protect the air conditioner. Do not attempt to repair this equipment by yourself. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name and the information that appeared in the remote controller display.
Why is my Mitsubishi Electric Mr. SLim PEAD-140JA Air Conditioner remote not working?
If nothing appears in the wireless remote controller display of your Mitsubishi Electric Air Conditioner, the display is faint, or signals are not received by the indoor unit unless the remote controller is close, the batteries are likely low. Replace the batteries and press the Reset button. If nothing appears even after replacing the batteries, ensure they are installed in the correct directions (+, –).
How to fix Mitsubishi Electric Air Conditioner not cooling well?
If your Mitsubishi Electric Air Conditioner isn't heating or cooling well, start by cleaning the filter, as reduced airflow from a dirty or clogged filter can be the cause. Also, check the temperature settings and adjust accordingly. Ensure there's enough space around the outdoor unit for proper ventilation. Verify that the air intake or outlet of the indoor unit is not blocked. Finally, make sure no doors or windows are left open.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | Mr. SLim PEAD-140JA |
| Category | Air Conditioner |
| Language | English |
